GPS Tracker using ESP8266

We will use the following components:

• NodeMCU (it has a built-in ESP8266)
• GPS receiver (you can use the Ublox NEO-6M GPS Module)
• A few cables
• Power source
• A smartphone (for the Blynk)

To make the connection, follow the pin configurations with NodeMCU and the GPS receiver:

NodeMCU	GPS receiver
D1	TX
D2	RX
GND	GND
VCC	3V

 

See the following circuit for clarification:

1. Now, connect the NodeMCU to the computer and open the Arduino application to program the NodeMCU. Before uploading the code, let's open our Blynk app.
2. Create a new project, as we discussed in Chapter 3, Preparing Your Drone for Flying.
3. Remember the authentication code sent to the email address you registered with the app; this will be needed later. In my case, I have set my project name as MY GPS TRACKER, device type as NodeMCU, and connection type WiFi, as follows:

4. To see the real-time location in text value, add two text fields with Labeled Value.
5. For latitude, set the pin type Virtual and pin V1:

6. For longitude, select pin...